[ CAPS
Eye End ] [ CAPS
Threaded ] [ Bar Clamps ] [ Head Rod Clamps ] [ Tie-Down
Clamps ]
[ SlipFit Elbows ] [ Camel Back HINGES ] [ Post Sockets ] [
RAIL
and WELT ] [ Cleats ]
[ Prev
] <Awning FITTINGS> [ Next ] |
Aluminum
3/4"
Projection CAMEL Back HINGE
Camel
Back hinges that move the pivot point out from the surface to
allow full range
of movement of eye ends, projection distance is
given from the mounting surface.
#AL-2404-
pack |
3/4"projection
|
|
|
Select "ADD To
CART"... Type
QUANTITY & Update |
One-Inch projection
|
Aluminum 1"
Projection CAMEL BACK HINGE
Camel
Back hinges that move the pivot point out from the surface to
allow full range
of movement of eye ends, projection distance is
given from the mounting surface.
#AL-2406-
pack
|
|
|
Aluminum AWNING RAIL
~ Awning Trailer
Molding
Mill-Finish Awning Rail,
cut to approx. 8-foot lengths for Shipping.
1-1/4"wide (3.2cm); 3/16"-slit (0.5cm), Includes
Two 8ft Lengths (16-feet Total)
#2771-c
For Two 8-ft-lengths (16-feet total)
|
Aluminum
Trailer Mould
AWNING RAIL |
| If you are not sure of sizing,
Call before ordering, since All Sales Are Final... Thanks |
[ Prev ] < Awning FITTINGS > [ Next ]
Malleable Alloy Available on Select
items (25% Add'l; by Request).
*Note: Select Carefully,
since All Sales Are Final...
[ CAPS
Eye End ] [ CAPS
Thread Eye ] [ Bar Clamps ] [ Head Rod Clamps ] [ Tie-Down
Clamps ]
[ SlipFit Elbows ]
[ Camel Back HINGES ] [ Post Sockets ] [ Awning RAIL
and WELT ] [ Cleats ]
The aluminum hardware is cast alloys that are best
suited to each applications.
All parts have a smooth surface with
a bright finish. Set screws, hinge screws,
bolts and nuts are of
stainless steel unless otherwise indicated. Littco.
Many
of the parts appear similar to their counterparts in the boat top
trade,
they tend to be larger castings and in many cases are not
as well finished
as the equivalent boat parts. |
